How To Handle Power Interuptions; Special Function Buttons - Primus RF6 Programming Manual

ATTENTION !!!
!
IT'S UP TO THE OPERATOR TO TAKE THE NECESSARY PRECAUTIONS IF THE DRAIN VALVE IS
NOT FUNCTIONAL AND THERE IS STILL HOT WATER IN THE TUB AT THE END OF THE WASH
CYCLE.
ON THE DISPLAY THE ACTUAL WATER TEMPERATURE AND LEVEL WILL BE DISPLAYED.
WAIT UNTIL THE WATER IS DRAINED AND UNTIL THE WATER HAS COOLED BEFORE ALL
INTERVENTIONS AS HOT WATER CAN CAUSE BURNS.
If something goes wrong with the door lock, the program will be finished immediately.
For safety purposes, the door will stay locked.
ATTENTION !!!
!
GO TO THE CHAPTER 8 TROUBLE SHOOTING TO FIND OUT MORE ABOUT ERROR HANDLING.

6.23. HOW TO HANDLE POWER INTERUPTIONS

When a power interruption occurs while the machine is in standby mode and no program cycle was
started, the machine will stay in standby mode.
When a power interruption occurs while the machine is washing or spinning, after the power
interruption, the message Continue ? will be displayed.
STOP : the program is stopped. (A tumble sequence will be executed before the door can be opened.)
START : the program restarts the last active step, and goes on with the rest of the program.

6.24. SPECIAL FUNCTION BUTTONS

The Special Function buttons Info and Service are dedicated to supply the operator with more information
about the wash programs and the wash machine functions.
The other Special Function buttons allow direct operation.
6.24.1. INFO
Press the INFO button if you want to find out what a program looks like.
If no Program number has been selected, you will get an overview of all the available programs.
If a Program number has been selected, you will get a detailed list of the program functions, step
by step.
By pressing the ARROW DOWN button you will see all the menu items.
At the end of a step, EXIT is displayed. By pressing the ENTER button you will go over to the next step.
You can leave the Info menu by pressing the INFO button again.
6.24.2. SERVICE - STATE
Press the SERVICE-STATE button if you want to inspect the actual water temperature and level.
At the Service - State menu, you can inspect :
- the water temperature and water level
- the number of cycles that have been accumulated (service due)
100962 G PUBLICATION DATE 24 JUN 2008.DOC PROGRAMMING MANUAL 79