Initializing The Machine; Initialisation Menu - Primus RF6 Programming Manual

4. INITIALIZING THE MACHINE

Initializing the machine goes in four steps:
1. Install the machine mechanically. (See Installation Manual)
Full Control Wash Computer only :
2. Select the machine specific settings in the Configuration Menu.
3. Select the operator specific settings in the Initialisation Menu.
4. Adjust standard Programs or create new Programs at the Program Menu.
ATTENTION !!!
!
THE INITIALISATION SHOULD BE PERFORMED BY QUALIFIED PERSONNEL ONLY. AN INCORRECT
INITIALISATION MAY CAUSE SERIOUS INJURIES AND SERIOUS DAMAGE TO THE MACHINE!
ATTENTION !!!
!
BEFORE MAKING CHANGES IN THE CONFIGURATION AND INITIALISATION MENU READ
THIS MANUAL CAREFULLY.
CHANGES YOU HAVE MADE WILL INFLUENCE THE WASH PROGRAM PROCESSES.
WE RECOMMEND BEFORE MAKING CHANGES TO CAREFULLY WRITE DOWN WHAT THE
PREVIOUS SETTINGS WERE.
AS THE FULL CONTROL WASH COMPUTER IS USED FOR A WHOLE RANGE OF WASHING
MACHINES, AFTER THE INSTALLATION OF A NEW FULL CONTROL WASH COMPUTER, YOU
NEED TO PROGRAM MACHINE SPECIFIC SETTINGS INTO THE CONFIGURATION MENU. See
paragraph 4.2.
AT THE INSTALLATION OF NEW SOFTWARE, AFTER LOADING THE FACTORY SETTINGS (see
paragraph 4.2) YOU NEED TO CHECK THE DEFAULT SETTINGS ONE BY ONE TO FIND OUT IF
THEY CORRESPOND WITH THE SETUP AS YOU PREFER.
THE CONFIGURATION AND INITIALISATION OF THE WASHING MACHINE HAS BEEN DONE
AT THE FACTORY. FOR THE CREATION OF NEW PROGRAMS, NO CHANGES HAVE TO BE MADE
IN THE INITIALISATION OR CONFIGURATION MENUS.

4.1 INITIALISATION MENU

HOW TO GET INTO THE INITIALISATION MENU
The initialisation menu can only be accessed when the machine is in standby (the power is switched on, but
no program is started).
SELECT Process_ _ is displayed.
Turn the key switch to the Program Mode.
The Main menu is now available.
The Initialisation Menu is the first Menu and is displayed immediately.
Main Menu
Initialisation
Press the ENTER button to make your selection.
Now you will see the first menu item.
By pressing the
22
ARROW DOWN or UP button you can see the menu items one by one.
PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC