Primus RF6 Programming Manual page 101

ATTENTION !!!
!
SPECIAL CARE HAS BEEN TAKEN AT THE INITIALISATION OF THE PARAMETERS OF THE
MITSUBISHI FREQUENCY INVERTER.
THE MANUFACTURER IS NOT RESPONSIBLE FOR THE WRONG BEHAVIOR OF THE
WASHING MACHINE IF THE OWNER HAS INSTALLED NEW PARAMETER SETTINGS IN THE
INVERTER THAT DO NOT CORRESPOND WITH THE ORIGINAL SETTINGS AT THE FACTORY.
S:Pulley
Ratio : XX
S:View Input
States ?
S:Input 1 Off
S:Reset Cycle
Counter : No
100962 G PUBLICATION DATE 24 JUN 2008.DOC
• XX is the Pulley Ratio.
• You can check if the motor pulley and the drum pulley have
the correct size by calculating the pulley ratio.
• This value should be about the same as the displayed value.
• Press the ARROW DOWN button to select the next menu item.
• If you don't want to see the Input States, press
the ARROW DOWN button.
• If you want to see the Input States, press the
ENTER button.
• Input 1 : the State that corresponds with Input 1.
Input 2 : the State that corresponds with Input 2.
...
Input 16 : the State that corresponds with Input 16.
• The exact function of the inputs can be found on the
electrical drawing of the Full Control Wash Machine.
• If the Input state is Off, the Input signal is low.
• If the Input state is On, the Input signal is high.
• Press the ARROW DOWN button to see
message by message and to leave the Input state menu.
• To avoid that No maintenance will be fulfilled when the
machine has reached the number of cycles that corresponds
with the "Service Interval _ _ _" number at the Initialisation
menu, a warning will be generated over and over again at the
end of each cycle until the Cycle Counter at the Service
menu has been reset.
• Also the Statistics for Error messages will be Reset by
resetting the Cycle counter.
• If you don't want to reset the Cycle Counter,
press the ARROW DOWN button.
• Press the YES and ENTER button if you want to
reset the Cycle Counter.
PROGRAMMING MANUAL 99