Programming A Delay Time; Economic; The Active Program - Primus RF6 Programming Manual

MB-machines only.
After pressing the „START" button a message appears with the request to verify if you have
locked the Inner Door.
Did you lock
the Inner Door ?
Press the „START" button if you are sure that you have locked the Inner Doors mechanically.
If you are not sure press the "STOP" button and check the Inner Doors visually.

6.6. PROGRAMMING A DELAY TIME

Enter the selected Program Number.
Press the Dot button.
The Delay time message will be displayed.
The Door and the Soap Door must be closed first.
Now you can insert the value for a delay time
Delay _ _ : _ _
First insert a value for the Hours, then insert a value for the Minutes
The minimum delay time is 1 minute [ 00:01]
The maximum delay time is 99 hours and 59 minutes [99:59]
By pressing the START button, the delay time will start to decrease.
The Door will be locked immediately.
Once the delay time is over, the wash cycle will start automatically.
The Delay Time Sequence can be interrupted by pressing the Stop button.
The program will return to the Start Up menu : Select Process _ _ .

6.7. ECONOMIC

If you accept the selection ECONOMIC at the Start of a new cycle by pressing the YES button, the
water level will be lowered by 20% ( in units) in accordance with the programmed level.
If you don't want an ECONOMIC level, press the NO button.
ECONOMIC water levels should only be used for lightly soiled and/or smaller volumes of garments.
In other cases these reduced water levels will give poor washing quality.
In the Initialisation Menu you can enable/disable the request for ECONOMIC at Start UP.

6.8. THE ACTIVE PROGRAM

The cycle time will decrease minute by minute and gives you an indication how long it will take
before the cycle is finished.
For each Wash program Step :
- first you will see the Wash Sequence
- then you will see the Drain / Extraction Sequence
A row of bars, shows you if the Sequence has just been started or if ¼, ½ or ¾ of the Sequence
time is over.
100962 G PUBLICATION DATE 24 JUN 2008.DOC PROGRAMMING MANUAL 73