Primus RF6 Programming Manual page 105

Diagnostic Test Sequence for Machines with Front Soap Hopper.
Test (2) : For washing machines with 2 Main Water Supplies.
Test (3) : For washing machines with 3 Main Water Supplies.
Test Test
(2) (3)
1 1
*** ***
3 3
4 4
5 5
6 6
7 7
8 8
9 9
20
21
20 22
21 23
22 24
24 26
26 28
28 30
30 32
32 34
50 50
Note : * The second drain valve will be opened if the second drain valve has been selected in the
Configuration menu.
** For X/XF and MB Door lock test only 1x (X/XF22 5x)
***No number 2 is displayed at the sensor test as this takes only a fraction of a second.
Remark !
If ++ ++ is displayed at the upper right corner of the display at the motor test sequence, then you
can Advance (Press START) the test Sequence.
100962 G PUBLICATION DATE 24 JUN 2008.DOC
Info
Black display followed
by a Text display.
None
Reverse
Stop
Forward
Distribute
Low Extract
High Extract
Stop
I1
Drain 1
I2
Drain 1 (2)*
I3
A
B
C
D
E
Tumble
Unload
Explanation
Door lock test (locks and unlocks 5 x the door)
Display test (**)
Sensor test (all wash machine sensors are
tested)
Wash speed (inverse direction high spin)
⇒ Standstill motor
Wash speed
Distribution speed (same direction high spin)
Low spin speed
High spin speed
(the drum is turning away from the soap box)
Free run or controlled deceleration
The machine takes water by inlet 1
The water is drained by drain valve 1
The machine takes water by inlet 2 until the
safety level for heating is reached
Heating activated (only if Wait temp = on)
The water is drained by drain valve 1
The machine takes water by inlet 3
Supply 1 is activated for 30"
Supply 2 is activated for 30"
Supply 3 is activated for 30"
Supply 4 is activated for 30"
Supply 5 is activated for 30"
⇒ The tumble sequence
⇒ End of the Diagnostic Cycle
PROGRAMMING MANUAL
(same direction high spin)
(same direction high spin)
103