Primus RF6 Programming Manual page 48

P:Pr XX Step XX
Supply ?
P:Pr XX Step XX
Supply A: 0 Sec
P:Soap Supply
Menu Exit
↵
P:Pr XX Step XX
On Time : _ _ Sec
P:Pr XX Step XX
Off Time: _ _ Sec
P:Pr XX Step XX
Time : 4.0 Min
46
• If you don't want to get in the supply sub-menu, press the
ARROW DOWN button.
• Press the ENTER button to get into the supply sub-menu.
• Default: all the supplies are switched off. (time = 0)
• Liquid soap supplies can only be programmed if the liquid
selection in the configuration menu is enabled.
• The supplies can be programmed for an interval time
between 0 and 99 seconds.
• The supply will not be activated if 0 Seconds is programmed.
• You can program up to 4 supplies at the same time.
If you have programmed more then 4 supplies an error
message will be generated. Put the time of the supplies back
to zero until not more than 4 non-zero time values are
remaining.
• The overview display shows the Supply Name and the
corresponding programmed time.
• Insert the desired supply time. Press the ENTER
button for confirmation.
• At the end of the Menu, when EXIT is displayed, press the
ENTER button to leave the supply Menu.
Attention !
!
For Top Soap Hopper washing machines, the External liquid
soap pumps correspond with the supplies D to N.
The number of external supplies that is available depends
on the machine type.
• The wash motor ON time can be programmed between 0 and
99 seconds.
• The wash motor OFF time can be programmed between 3
and 99 seconds.
• The suggested default values can be adapted in the
Initialisation menu.
• Standard wash motor ON time of 12 seconds and a wash
motor OFF time of 3 seconds is recommended for normal
wash. A wash motor ON time of 3 seconds and a wash motor
OFF time of 12 seconds is recommended for a gentle wash
(woolens).
• Insert the desired ON – OFF times. Press the ENTER
button for confirmation.
• A PreWash sequence can be programmed between 0 and
99.5 minutes in steps of 0.5 minutes.
• The default time is 4.0 Minutes.
• Programming a time of 0 minutes : the Prewash Sequence
will not be functional (cfr No Wash)
PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC