Primus RF6 Programming Manual page 36

C:Full
Heating : 67 %
C:Wet
Cleaning : No
C:Drum
Compartments : 2
C:Wall
Model : No
34
• Confirm by pressing the ENTER button.
• Full Heating 0-100 (%)
This function allows to reduce the energy consumption at
Long hot washes.
• When the heating has reached the programmed target
temperature, heating will be restarted when the bath
temperature goes below the temperature hysteresis.
- Full Heating 100 %, the heating will be restarted until the
end of the hot wash sequence.
- Full Heating 0 %, the heating will not be restarted once the
target temperature has been reached.
- Full Heating 67%, the heating will be switched Off 1/3
before the end of the hot wash sequence.
• In case of a hygienic program, 100% must be selected.
• 67% is the default value except for MB machines 100%.
• Confirm by pressing the ENTER button.
• By selecting Wet Cleaning Yes its possible to program water
levels below the standard minimum programmable levels.
As a result (safety) the heating is software disabled when
Wet Cleaning is selected Yes.
• No is the default value.
• Yes : Very low water levels are programmable.
No : Water levels below minimum programmable are not
programmable.
• Confirm by pressing the ENTER button.
• Only for MB90, MB140, MB180 Washing machines.
• Big MB machines can be execute with 2 or 3 drum
compartments.
• 2 is the default value.
• By pressing the ARROW LEFT or RIGHT button, you can
adjust the value. Press the ENTER button to confirm.
• Only for MB Washing machines.
( Medical Barrier Washers)
• If the MB machine is a Wall model then Yes must be selected.
• No is the default value.
• Confirm by pressing the ENTER button.
PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC