Primus RF6 Programming Manual page 109

FAILURE 5 : OUT OF BALANCE HIGH SPIN
Failure 5 occurs when the out of balance sensor is activated at high spin. This failure indicates that there will
be probably a mechanical defect.
DIAGNOSE:
1. Check the position of the out of balance
switch
2.Check the springs and the other mechanical
parts that fix the drum.
3. Check the wiring if there is a bad
connection
4. Check that the washing machine is installed
correctly and stable.
FAILURE 6 : DOOR SWITCH FAILURE
For safety reasons : while a process is running the door lock system is scanned all the time.
If the controller detects that the "DOOR SWITCH" is not closed then the machine will immediately stop all its
functions. The door will stay locked.
DIAGNOSE:
1. Check the well functioning of
the "DOOR SWITCH". The "DOOR
SWITCH" is a NO normal open contact.
2. Check the continuity of the wiring
3. Check the functioning of RL20
FAILURE 7: DOOR SOLENOID SWITCH FAILURE
For safety reasons: the door locked system is scanned all the time.
If the machine detect that the "DOOR SOLENOID SWITCH" is not closed then the machine will immediately
stop all its functions. The door will stay locked.
DIAGNOSE:
1. Check the functioning of the "DOOR
SOLENOID SWITCH".
The "DOOR SOLENOID SWITCH" is a NO
open contact.
2. Check the door lock coil
3. Check the mechanical functionality
of the door lock.
4. Check the continuity of the wiring
FAILURE 8: DOOR LOCK CHECK AT START FAILURE
The washing machine will not start a new process when the door is not locked after pressing the START
button.
The Message DOOR ! is displayed.
When you open the door : the fault message is erased.
Exeption :
If the „DOOR SWITCH" is opened again just before the cycle has started, (the „DOOR SOLENOID SWITCH"
is still closed) Fault message 8 will also be generated.
100962 G PUBLICATION DATE 24 JUN 2008.DOC
If the out of balance switch is not correctly mounted,
install the out of balance switch properly
If you see a broken mechanical part: replace the
broken part
If there is a bad connection: repair the wiring
Adjust the supports at the bottom of the washing
machine.
If the "DOOR SWITCH" is broken or malfunctions
replace the door switch
If the wiring is not continuous: repair the wiring
If RL20 is not functioning replace the electronic board.
If the „DOOR SOLENOID SWITCH" is broken or
functions not 100%: replace the door lock system
If the door lock coil doesn't function: replace the door
lock coil
If the door lock is not functioning mechanically: replace
the door lock system
If the wiring is not continuous: repair the wiring
PROGRAMMING MANUAL 107