Primus RF6 Programming Manual page 64

THE FLUSH SEQUENCE
Prewash | Wash | Cooldown | Rinse |
Only for Top Soap Hopper washing machines.
No water level can be programmed as the water will raise and escape by the overflow hole.
No inlets can be programmed as only cold water from inlet 6 is used.
No supplies can be programmed.
P:Pr XX Step XX
RPM : _ _
P:Pr XX Step XX
On Time : _ _ Sec
P:Pr XX Step XX
Off Time : _ _ Sec
P:Pr XX Step XX
Time : 10.0 Min
62
Final Rinse | Soak |
• The suggested drum speed value depends on the machine
type.
• Check the corresponding table paragraph 3.4.
• The drum speed value can only be programmed within
certain limits.
• Insert the desired speed value. Press the ENTER button for
confirmation.
• The wash motor ON time can be programmed between 0 and
99 seconds.
• The wash motor OFF time can be programmed between 3
and 99 seconds.
• The suggested default values can be changed in the
Initialisation menu.
• Standard wash motor ON time of 12 seconds and a wash
motor OFF time of 3 seconds is recommended for normal
wash. A wash motor ON time of 3 seconds and a wash motor
OFF time of 12 seconds is recommended for a gentle wash
(woolens).
• Insert the desired ON – OFF times. Press the ENTER button
for confirmation.
• The Flush Sequence can be programmed between 0 and
99 minutes in steps of 0.5 minutes.
• The Default time is 10.0 Minutes.
• Programming a time of 0 minutes : the Flush will not be
functional (cfr No Wash)
• Insert the desired Flush Sequence time. Press the ENTER
button for confirmation.
PROGRAMMING MANUAL
Flush
| Spray | No wash
100962 G PUBLICATION DATE 24 JUN 2008.DOC