Warnings And Symbols; Warnings - Primus RF6 Programming Manual

2. WARNINGS AND SYMBOLS

2.1. WARNINGS

BEFORE OPERATING A MACHINE CONTROLLED BY AN ELECTRONIC PROGRAMMER, READ THIS
MANUAL. INCORRECT USE CAN RESULT IN SERIOUS INJURIES OR DAMAGE TO THE MACHINE
CONTROLS. IGNORING INSTRUCTIONS CAN CAUSE AN INCORRECT MACHINE FUNCTION, WHICH
MAY RESULT IN INJURIES OR MACHINE AND/OR LINEN DAMAGES.
– This manual version is an original English version. Without the original version these instructions are not
complete. Before installation, operating and maintenance of the machine, read complete instructions
thoroughly which means the following manuals: „Programming Manual", „User's Manual" and „Installation
and Maintenance Manual". Follow these instructions and keep them handy for later use.
– A machine must be installed by following the „Installation and maintenance manual". Before the first machine
start, it must be initialized and tested by a qualified worker. When operating the machine, follow the
machine „Users Manual".
– The electric service line must not be affected by other electrical loading. A nominal voltage, if loaded or not
must work in the range ±10% with a maximum permanent frequency deviation of 1% or a short-time one at
2% of a given frequency (50 or 60 Hz). Connecting or starting the machine at an incorrect voltage can
damage the programmer.
– The machine must not be exposed to high humidity or extreme high and low temperatures.
– Do not tamper with the controls.
INSTRUCTIONS IN THIS MANUAL DO NOT COVER ALL DANGEROUS SITUATIONS.
IT IS UP TO THE USER TO HANDLE THE MACHINE CAREFULLY.
The manufacturer has the right to change specifications in this manual without prior notice. All the stated
information is only for informative purpose and must be considered as general. It is not possible to present all
the specific data of the device.
NOTE !!!
EVERY ELECTRONIC BOARD HAS A SERIAL NUMBER AND THE CODE OF THE BOARD (Picture 9.3).
ON THE EPROM MEMORY CHIP ON THE ELECTRONIC BOARD IS A LABEL SPECIFYING THE
SOFTWARE NUMBER AND VERSION AND/OR THE DATE OF THE SOFTWARE (Picture 9.3).
THESE DATA, AS WELL AS THE MODEL AND SERIAL NUMBER OF THE MACHINE, MUST BE
MENTIONED IN ALL CORRESPONDENCE OR INQUIRIES ADDRESSED TO THE DISTRIBUTOR OR
MANUFACTURER.
NOTE !!!
THE "FULL CONTROL" COMPUTER USED 'MACHINE TYPE' CODES TO SELECT THE DIFFERENT
PROGRAMMABLE MACHINES EXECUTIONS.
The model number on de machine doesn't indicate the 'machine type' but must be linked with the
description of the 'machine type' letters.
R : Rigid mounted machines (MFR PND)
RF : Rigid mounted inverter driven machines
F : Free standing machines (MFS PND)
FF : Free standing Frequency inverter driven machines (MFS NNA)
X : Non cabinet machines (MFX PND)
XF : Non cabinet Frequency inverter driven machines (MFX NN)
MB : Medical Barrier machines.
NOTE !!!
IN THE PROGRAMMING MANUAL, SOME PARAGRAPHS ARE ONLY INTENDTED FOR MACHINES
WITH FREQUENCY INVERTER CONTROLED MOTOR. THESE ARE RECOGNIZABLE AT THE TEXT
PRINTED IN ITALICS ON A PALE GREY BACKGROUND. IF YOUR MACHINE IS NOT A FREQUENCY
CONTROLLED MACHINE, YOU SHOULD IGNORE THESE PARAGRAPHS.
100962 G PUBLICATION DATE 24 JUN 2008.DOC PROGRAMMING MANUAL 3