Advancing A Wash Program; Wash Time; Program End - Primus RF6 Programming Manual

PrXX StYY ZZ.Z Min
Wash
PrXX
StYY
ZZ.Zmin or ZZ.Z H
Wash

6.9. ADVANCING A WASH PROGRAM

Press the ARROW RIGHT button to increase the wash sequence time.
Press the ARROW LEFT button to decrease the wash sequence time.
Press the START button to skip the current step.
>> >> is displayed instead of the remaining time at the moment that the step is skipped.
ATTENTION !!!
!
EVEN IF THE ADVANCE FUNCTION HAS BEEN SWITCHED OFF IN THE INITIALISATION MENU,
THE ADVANCE FUNCTION WILL WORK IF THE KEY SWITCH IS TURNED INTO PROGRAM MODE.

6.10. WASH TIME

Once the program has been started, the remaining cycle time is displayed.
Sometimes the dot of the displayed time stops blinking to indicate that the time on the display stops
counting down.
The time that the dot stops blinking is extra time.
The total wash time = programmed time (1) + the extra time (2+3+4+5)
1. The programmed time of the processes.
2. The extra time for taking water.
3. The extra time for draining (if the water is not drained in 30 sec and the extended drain
time is started)
4. The extra time for heating if „Wait for temperature" is selected.
5. The extra free run time at the end of the spin sequence.

6.11. PROGRAM END

The time on the display counts down until 0.
Once the program cycle is finished, END PROGRAM is displayed.
The Door Lock will be released. You can open the Door when UNLOAD appears on the
Display.
Open the door and unload the machine.
The Message UNLOAD will be erased and the machine is ready to start a new program.
SELECT PROCESS _ _ is displayed.
74
: The selected program number.
: The selected program Step.
: The remaining program time in 1/10 of Minutes or 1/10 of Hours.
: A row of bars appears as a function of the remaining sequence time.
: The executed Sequence. (example, Wash)
PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC