Primus RF6 Programming Manual page 14

ATTENTION !!!
!
FOR MACHINES WITH LIQUID SUPPLY PUMPS, DIRECT WATER INLET VALVES 3 OR 6 MUST BE
PROGRAMMED BECAUSE THE LIQUID IS ADDED AT THE DIRECT WATER INLET CHANNEL.
DEPENDING THE WASHING MACHINE EXECUTION, WATER INLET VALVE 1 WILL FUNCTION WITH
COLD WATER.
FOR WASHING MACHINES WITH WATER RECYCLING, THE WATER RECYCLING SUPPLY MUST
BE CONNECTED TO INLET VALVE 2 OR 5
Front or Side Soap Hopper washing machines :
The cold water inlet valves
Inlet Valve 1 :
Inlet Valve 2 :
The hot water inlet valve
Inlet Valve 3 :
ATTENTION !!!
!
FOR A FRONT SOAP HOPPER WASHING MACHINE, TO ADD SOAP, THE SUPPLIES MUST BE
PROGRAMMED.
Programming the water level
– Water level Limits
See table 3.4 A and 3.4 B as these values are different for each machine type.
Minimum value : above the heating elements and the temperature sensor
Maximum value : below the overflow outlet
– Normal Low Level, Normal High Level
The Normal Low Level is recommended for the PREWASH, WASH and SOAK sequences.
The Normal High Level is recommended for the RINSE and FINAL RINSE Sequences.
At the FLUSH sequence, you can't program a water level as the water will escape by the
overflow opening.
At the COOLDOWN sequence, the Full Control Wash Computer makes use of a low water
level and is draining the water automatically.
At the Spray sequence, the Drain valve stays open.
– Economic water level
If you prefer a wash cycle with an economic water level :
– you can select "Show ECONOMIC" in the initialisation menu to make use of the standard
ECONOMIC function. Then at the start of each wash cycle, the question ECONOMIC?
will be posed. If you select ECONOMIC then the program will function with 20% units less water.
– or you may make dedicated programs with a water level 20% units below the Normal
water level.
– Wet Cleaning selection Configuration menu
It's possible to program a level below default minimum programmable level. (see table)
The extra heating is disabled by the software if Wet Cleaning has been selected.
ATTENTION !!!
!
FOR WOOLENS AND OTHER DELICATE LINEN A NORMAL HIGH WATER LEVEL IS RECOMMENDED.
THE ECONOMIC FUNCTION SHOULD ONLY BE USED FOR LIGHTLY SOILED AND/OR SMALLER
VOLUMES OF LAUNDRY. IN OTHER CASES, THE PROGRAM WILL GIVE POOR WASHING QUALITY.
12
Cold Hard Water or Recycled Water
Cold Soft Water
Warm Soft Water
PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC