Subaru IMPREZA GD 2007 Series Manual page 93

asieps_tobira_IM_US.book 2 ページ ２０１２年１月１７日 火曜日 午後３時４８分
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
1. General Description
A: CAUTION
• Wear appropriate work clothing, including a cap,
protective goggles and protective shoes when per-
forming any work.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Vehicle components are extremely hot after driv-
ing. Be wary of receiving burns from heated parts.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Before disconnecting connectors of sensors or
units, be sure to disconnect the ground cable from
the battery.
B: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
ST18353AA000
General Description
TOOL NUMBER DESCRIPTION
18353AA000 CLAMP PLIERS
EC(H4SO)-2
REMARKS
• Used for removing and installing the PCV
hose.
• This is a general tool made by the French
company CAILLAU. (Code: 54.0.000.205)
To make this easier to obtain in the same way as
genuine Subaru parts, it has been provided with
a tool number as an ST.