asieps_tobira_IM_US.book 29 ページ 2012年1月17日 火曜日 午後3時48分
8. General Scan Tool
A: OPERATION
1. HOW TO USE GENERAL SCAN TOOL
1) Prepare a scan tool (general scan tool) required
by SAE J1978.
2) Open the cover and connect the general scan
tool to the data link connector located in the lower
portion of instrument panel (on the driver's side).
3) Using the general scan tool, call up DTC and
freeze frame data.
General scan tool functions consist of:
(1) MODE $01: Current powertrain diagnostic
data
(2) MODE $02: Powertrain freeze frame data
(3) MODE $03: Emission-related powertrain
DTC
(4) MODE $04: Clear/Reset emission-related
diagnostic information
(5) MODE $06: Request on-board monitoring
test results for intermittently monitored systems
(6) MODE $07: Request on-board monitoring
test results for continuously monitored systems
(7) MODE $09: Request vehicle information
Read out the data according to repair procedures.
(For detailed operation procedure, refer to the gen-
eral scan tool instruction manual.)
NOTE:
For details concerning DTC, refer to "List of Diag-
nostic Trouble Code (DTC)".
<Ref. to EN(H4SO)(diag)-72, List of Diagnostic
Trouble Code (DTC).>
General Scan Tool
EN-01163
EN(H4SO)(diag)-29
ENGINE (DIAGNOSTICS)