Subaru IMPREZA GD 2007 Series Manual page 429

asieps_tobira_IM_US.book 8 ページ ２０１２年１月１７日 火曜日 午後３時４８分
EXHAUST
4. Rear Exhaust Pipe
A: REMOVAL
CAUTION:
Be careful not to burn yourself, because the ex-
haust pipe becomes extremely hot after run-
ning.
1) Set the vehicle on a lift.
2) Lift up the vehicle.
3) Separate the rear exhaust pipe from center ex-
haust pipe.
4) Separate the rear exhaust pipe from muffler.
CAUTION:
Be careful not to pull down the rear exhaust
pipe.
5) Apply a coat of spray type lubricant to the mating
area of cushion rubber.
6) Remove the rear exhaust pipe bracket from
cushion rubber.
Rear Exhaust Pipe
B: INSTALLATION
1) Apply a coat of spray type lubricant to the mating
area of cushion rubber.
2) Install the rear exhaust pipe bracket to cushion
rubber.
NOTE:
After assembling, degrease the lubricant which
was applied to the cushion rubber while removing/
installing.
3) Install the rear exhaust pipe to muffler.
EX-00214
NOTE:
Use a new gasket and self-locking nut.
Tightening torque:
48 N·m (4.9 kgf-m, 35.4 ft-lb)
EX-02125
4) Install the rear exhaust pipe to center exhaust pipe.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
EX-02126
C: INSPECTION
1) Check the connections and welds for exhaust leaks.
2) Make sure there are no holes or rusting.
3) Check the cushion rubber for wear or crack.
EX(H4SO)-8
EX-02126
EX-02125
EX-00214