Subaru IMPREZA GD 2007 Series Manual page 144

asieps_tobira_IM_US.book 35 ページ ２０１２年１月１７日 火曜日 午後３時４８分
5. READ CURRENT DATA FOR ENGINE (OBD MODE)
1) On the «Main Menu» display screen, select {Each System Check}.
2) On the «System Selection Menu» display screen, select {Engine Control System}.
3) Select the [OK] after the information of engine type has been displayed.
4) On the «Engine Diagnosis» display screen, select {OBD System}.
5) On the «OBD Menu» display screen, select {Current Data Display/Save}.
6) On the «Data Display Menu» display screen, select {Data Display}.
7) Using the scroll key, scroll the display screen up or down until the desired data is shown.
• A list of the support data is shown in the following table.
Contents
Number of diagnosis code
Condition of malfunction indicator light
Monitoring test of misfire
Monitoring test of misfire
Monitoring test of fuel system
Monitoring test of fuel system
Monitoring test of comprehensive component
Monitoring test of comprehensive component
Test of catalyst
Test of catalyst
Test of heating-type catalyst
Test of heating-type catalyst
Test of evaporative emission purge control system
Test of evaporative emission purge control system
Secondary air system test
Secondary air system test
Test of air conditioning system
Test of air conditioning system
Test of oxygen sensor
Test of oxygen sensor
Test of oxygen sensor heater
Test of oxygen sensor heater
Test of EGR system
Test of EGR system
A/F control #1
Engine load data
Engine coolant temperature signal
A/F correction value #1
A/F learning #1
Intake manifold absolute pressure
Engine speed signal
Vehicle speed signal
Ignition timing advance for #1 cylinder
Intake air temperature signal
Amount of intake air
Throttle opening angle signal
Front oxygen (A/F) sensor (Bank 1 Sensor 1)
Oxygen sensor (Bank 1 Sensor 1)
Oxygen sensor (Bank 1 Sensor 2)
A/F correction (Bank 1 Sensor 2)
Subaru Select Monitor
Display
Number of Diag. Code:
MI (MIL)
Misfire monitoring
Misfire monitoring
Fuel system monitoring
Fuel system monitoring
Component monitoring
Component monitoring
Catalyst Diagnosis
Catalyst Diagnosis
Heated catalyst
Heated catalyst
Evaporative purge system
Evaporative purge system
Secondary air system
Secondary air system
A/C system refrigerant
A/C system refrigerant
O2 Sensor Diagnosis
O2 Sensor Diagnosis
O2 Heater Diagnosis
O2 Heater Diagnosis
EGR system
EGR system
Fuel system for Bank 1
Calculated load valve
Coolant Temp.
A/F Correction Value #1
A/F Learning Value #1
Mani. Absolute Pressure
Engine Speed
Vehicle Speed
Ignition timing adv.#1
Intake Air Temp.
Mass Air Flow
Throttle Opening Angle
Oxygen sensor #11
Oxygen sensor #12
Oxygen sensor #12
A/F Correction #12
EN(H4SO)(diag)-35
ENGINE (DIAGNOSTICS)
Unit of measure Note (at idling)
— 0
— OFF
— Supp YES or NO
— Rdy YES or NO
— Supp YES or NO
— Rdy YES or NO
— Supp YES or NO
— Rdy YES or NO
— Supp YES or NO
— Rdy YES or NO
— Supp N/A
— Rdy N/A
— Supp YES or NO
— Rdy YES or NO
— Supp N/A
— Rdy N/A
— Supp N/A
— Rdy N/A
— Supp YES or NO
— Rdy YES or NO
— Supp YES or NO
— Rdy YES or NO
— Supp YES or NO
— Rdy YES or NO
— Normal CLOSE
% 23.0 %
°C or °F 92°C or 198°F
% –0.8 %
% +0.0 %
mmHg, kPa, 211 mmHg, 28.1 kPa,
inHg or psig 8.31 inHg or 4.08 psig
rpm 700 rpm
km/h or MPH 0 km/h or 0 MPH
° +16.0°
°C or °F 36°C or 97°F
g/s or lb/m 2.7 g/s or 0.36 lb/m
% 13 %
— Support
— Support
V 0.7 V
% 0.0 %