Subaru IMPREZA GD 2007 Series Manual page 382

asieps_tobira_IM_US.book 273 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1 CHECK FOR ANY OTHER DTC ON DISPLAY. Is any other DTC displayed?
2 CHECK ENGINE OIL.
3 CHECK EXHAUST SYSTEM.
4 CHECK AIR INTAKE SYSTEM.
5 CHECK FUEL PRESSURE.
WARNING:
Place "NO OPEN FLAMES" signs near the
working area.
CAUTION:
Be careful not to spill fuel.
Measure the fuel pressure. <Ref. to ME(H4SO)-
28, INSPECTION, Fuel Pressure.>
CAUTION:
Release fuel pressure before removing the
fuel pressure gauge.
6 CHECK ENGINE COOLANT TEMPERATURE
SENSOR.
1) Start the engine and warm-up completely.
2) Read the data of engine coolant tempera-
ture sensor signal using Subaru Select Monitor
or general scan tool.
NOTE:
• Subaru Select Monitor
For detailed operation procedures, refer to "READ
CURRENT DATA FOR ENGINE". <Ref. to
EN(H4SO)(diag)-32, Subaru Select Monitor.>
• General scan tool
For detailed operation procedure, refer to the
general scan tool operation manual.
Check
Is there a proper amount of
engine oil?
Are there holes or loose bolts
on exhaust system?
Are there holes, loose bolts or
disconnection of hose on air
intake system?
Is the measured value 339.5 —
360.5 kPa (3.5 — 3.7 kgf/cm
49 — 52 psi)?
Is the engine coolant tempera-
ture 75°C (167°F) or higher?
EN(H4SO)(diag)-273
ENGINE (DIAGNOSTICS)
Yes No
Check the appro- Go to step 2.
priate DTC using
the "List of Diag-
nostic Trouble
Code (DTC)".
<Ref. to
EN(H4SO)(diag)-
72, List of Diagnos-
tic Trouble Code
(DTC).>
Go to step 3. Replace the
engine oil. <Ref. to
LU(H4SO)-8,
REPLACEMENT,
Engine Oil.>
Go to step 4.
Repair the exhaust
system.
Go to step 5.
Repair the air
intake system.
Go to step 6. Repair the follow-
2
, ing item.
Fuel pressure is
too high:
• Clogged fuel line
or bent hose
Fuel pressure is
too low:
• Improper fuel
pump discharge
• Clogged fuel line
Go to step 7.
Replace the
engine coolant
temperature sen-
sor. <Ref. to
FU(H4SO)-22,
Engine Coolant
Temperature Sen-
sor.>