Subaru IMPREZA GD 2007 Series Manual page 46

asieps_tobira_IM_US.book 3 ページ ２０１２年１月１７日 火曜日 午後３時４８分
B: PRE-DELIVERY INSPECTION (PDI) PROCEDURE
Perform the procedures indicated in the table below.
Static Checks Just After Vehicle Receipt
Operation
1. Appearance check
2. Tire check
3. Fuse installation
4. Air conditioner harness connection If the vehicle is about to be delivered to the customer, connect the air conditioner harness.
5. Lock/unlock and open/close
operation checks of doors
6. Operation check of child safety
lock system
7. Open/close operation checks of
trunk lid
8. Check the rear gate for lock/unlock
and open/close operations.
9. Operation check of trunk lid
release lever
10. Operation check of fuel lid opener
lock release lever
11. Accessory check
12. Operation check of front hood
lock release system
13. Battery
14. Brake fluid
15. Engine oil
16. Transmission fluid
17. AT front differential oil
18. Engine coolant
19. Clutch fluid
20. Window washer fluid
21. Front hood latch check
22. Keyless entry system
23. Security system
24. Seat
25. Seat belt
Pre-delivery Inspection
1. If the vehicle is covered with protective coating, visually check the vehicle body for
damage and dents. If the protective coating has been removed, visually check the painted
body surfaces in detail for damage or rust.
2. Visually check the glass and light lenses for any damage, cracks or excessive gaps
between body sheet metal.
3. Visually check the plated parts for any damage.
1. Check the tires for damage, defective, and dents on wheels.
2. Check the tire air pressure.
If the vehicle is about to be delivered to customer, attach the room lamp fuse.
1. Using the key, check the trunk lid can be locked or unlocked normally.
2. Open and close all doors to check that there are no problems.
3. Operate the power door lock switch to check that the rear gate locks and unlocks nor-
mally.
Check the child safety lock system operates normally.
1. Using the key, check that the trunk lid can be locked or unlocked normally.
2. Operate the trunk lock release lever to check that the trunk lid opens normally.
3. Use the valet key to check that the lock cannot be released.
4. Open and close the trunk lid to check that there are no problems.
1. Check if the rear gate can be unlocked normally through the emergency hole.
2. Open and close the rear gate to check that there are no problems.
Operate the trunk lid release lever to check that the trunk lock is unlocked normally.
Operate the fuel lid opener to check that the fuel filler lid can be unlocked normally.
Check that the following accessories are equipped.
• Owner's manual
• Warranty booklet
• Maintenance note
• Spare key
• Key No. plate
• Jack
• Tool set
• Spare tire
Operate the front hood lock release lever to check that the front hood opens normally.
Check the battery for any abnormal conditions such as rust or traces of battery fluid leaks.
Check the fluid level.
Check the engine oil level.
Check the fluid level.
Check the AT front differential oil amount.
Check the engine coolant level.
Check the clutch fluid amount.
Check the window washer fluid amount.
Check that the hood closes properly and that it can be locked securely.
Check that the keyless entry system operates normally.
Check that the security system operates normally.
1. Check the seat surfaces for stains or dirt.
2. Check the seat installation conditions and functionality.
Check the seat belt installation conditions and functionality.
PI-3
PRE-DELIVERY INSPECTION
Check point