Subaru IMPREZA GD 2007 Series Manual page 58

asieps_tobira_IM_US.book 15 ページ ２０１２年１月１７日 火曜日 午後３時４８分
43.AT SHIFT CONTROL
1) Turn the ignition switch to ON.
2) While brake pedal is not depressed, check if the
select lever does not move from "P" range.
3) While brake pedal is depressed, check if the se-
lect lever moves from "P" range.
4) Set the select lever to except for "P" range.
5) When the ignition switch is turned to OFF, check
if the ignition key switch cannot be removed.
6) Set the AT selector lever to each gear position
and check the shifting while driving the vehicle.
P
R
N
D
3
2
1
Selector position
1st
D OK
3 OK
2 —
1 OK
44.CRUISE CONTROL
Operate the cruise control system. Check that the
system is activated and deactivated correctly.
45.ATF LEVEL
After selecting all positions (P, R, N, D, 3, 2, 1), set the
select lever in "P" range. Idle the engine for 1 — 2
minutes, and measure the ATF level. If the amount is
insufficient, check that no leaks are found. Then, add
the necessary amount of the specified ATF.
(A)
(A) Level gauge
(B) Inspection position when "HOT"
70 — 80°C (158 — 176°F)
(C) Upper level
(D) Lower level
(E) Inspection position when "COLD"
[20 — 30°C (68 — 86°F)
Pre-delivery Inspection
PI-00077
Gear position
2nd 3rd 4th
OK OK OK
OK OK —
OK — —
— — —
(C)
(B)
(D)
(C)
(E)
(D)
PI-00105
PI-15
PRE-DELIVERY INSPECTION
46.POWER STEERING FLUID LEVEL
Check that the power steering fluid level is normal.
If insufficient, check for leaks. Then add the neces-
sary amount of the specified power steering fluid.
(A)
(C)
(B)
(A) Reservoir tank
(B) MIN. level
(C) MAX. level
47.FLUID LEAK CHECK
Check entire areas of the vehicle for any trace of
coolant/oil/fluid leaks.
48.WATER LEAK TEST
Spray the vehicle with water using a hose and check
that no water enters the passenger compartment.
• Before performing the water leakage test, re-
move anything that may obstruct the operation or
which must be kept dry.
• Close all the windows and doors securely. Close
the front hood, trunk lid and rear gate before start-
ing the test.
• Connect a hose to a tap, and spray water on the
vehicle. The rate of water spray must be approx. 20
to 25 2 (5.3 — 6.6 US gal, 4.4 — 5.5 Imp gal) per
minute.
When spraying water on areas adjacent to the floor
and wheel house, increase the pressure. When
spraying water on areas other than the floor and
wheel house, decrease the pressure. But the force
of water must be made strong occasionally by
pressing the end of the hose.
NOTE:
Be sure to keep the hose at least 10 cm (3.9 in)
away from vehicle.
Check the following areas.
• Front window and body framework mating portion
• Door mating portions
• Glass mating portions
• Rear quarter window mating portions
• Rear window and body framework mating portion
• Around roof drips
If any dampness in the compartments is discovered af-
ter the water has been applied, carefully check all the
areas that may have possibly contributed to the leak.
PM-00335