Subaru IMPREZA GD 2007 Series Manual page 150

asieps_tobira_IM_US.book 41 ページ ２０１２年１月１７日 火曜日 午後３時４８分
13) Perform subsequent procedures as instructed
on the display screen.
• If trouble still remains in the memory, the corre-
sponding DTC appears on the display screen.
NOTE:
• For detailed operation procedure, refer to the
"SUBARU SELECT MONITOR OPERATION
MANUAL".
• For details concerning DTC, refer to "List of Di-
agnostic Trouble Code (DTC)".
<Ref. to EN(H4SO)(diag)-72, List of Diagnostic
Trouble Code (DTC).>
• Release the parking brake.
• The speed difference between front and rear
wheels may illuminate the ABS warning light, but
this indicates no malfunctions. When engine
control diagnosis is finished, perform the ABS
memory clearance procedure of self-diagnosis
system.
3. GENERAL SCAN TOOL
1) After clearing the memory, check for any remain-
ing unresolved trouble data. <Ref. to EN(H4SO)(di-
ag)-47, Clear Memory Mode.>
2) Warm-up the engine.
3) Connect the test mode connector (A) located in
the lower portion of the instrument panel (on the
driver's side).
(A)
4) Connect the general scan tool to the data link
connector.
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor and general scan tool.
Inspection Mode
5) Start the engine.
NOTE:
• Ensure the selector lever is placed in "P" range
before starting. (AT model)
• Depress the clutch pedal when starting engine.
(MT model)
6) Using the selector lever or shift lever, turn the "P"
position switch and "N" position switch to ON.
7) Depress the brake pedal to turn the brake switch
ON. (AT model)
8) Keep the engine speed in 2,500 — 3,000 rpm
range for 40 seconds.
9) Place the select lever or shift lever in "D" range
(AT model) or 1st gear (MT model) and drive the
vehicle at 5 to 10 km/h (3 to 6 MPH).
NOTE:
• For AWD model, release the parking brake.
• The speed difference between front and rear
wheels may illuminate the ABS warning light, but
this indicates no malfunctions. When engine con-
trol diagnosis is finished, perform the ABS memory
clearance procedure of self-diagnosis system.
10) Using the general scan tool, check for DTC and
record the result(s).
NOTE:
• For detailed operation procedure, refer to the
general scan tool operation manual.
• For details concerning DTC, refer to "List of Diag-
nostic Trouble Code (DTC)".
<Ref. to EN(H4SO)(diag)-72, List of Diagnostic
Trouble Code (DTC).>
PI-00261
EN-01163
EN(H4SO)(diag)-41
ENGINE (DIAGNOSTICS)