Subaru IMPREZA GD 2007 Series Manual page 220

asieps_tobira_IM_US.book 111 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1 CHECK CURRENT DATA.
1) Start the engine.
2) Read the data of intake manifold absolute
pressure signal using Subaru Select Monitor or
general scan tool.
NOTE:
• Subaru Select Monitor
For detailed operation procedures, refer to
"READ CURRENT DATA FOR ENGINE". <Ref.
to EN(H4SO)(diag)-32, Subaru Select Monitor.>
• General scan tool
For detailed operation procedure, refer to the
general scan tool operation manual.
2 CHECK HARNESS BETWEEN ECM AND
MANIFOLD ABSOLUTE PRESSURE SEN-
SOR CONNECTOR.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from manifold
absolute pressure sensor.
3) Start the engine.
4) Read the data of intake manifold absolute
pressure signal using Subaru Select Monitor or
general scan tool.
NOTE:
• Subaru Select Monitor
For detailed operation procedures, refer to
"READ CURRENT DATA FOR ENGINE". <Ref.
to EN(H4SO)(diag)-32, Subaru Select Monitor.>
• General scan tool
For detailed operation procedure, refer to the
general scan tool operation manual.
3 CHECK HARNESS BETWEEN ECM AND
MANIFOLD ABSOLUTE PRESSURE SEN-
SOR CONNECTOR.
1) Turn the ignition switch to OFF.
2) Measure the resistance of harness between
manifold absolute pressure sensor connector
and engine ground.
Connector & terminal
(E21) No. 2 — Engine ground:
4 CHECK POOR CONTACT.
Check for poor contact of the manifold absolute
pressure sensor connector.
Check
Is the measured value 119.5
kPa (896.5 mmHg, 35.29 inHg)
or more?
Is the measured value 119.5
kPa (896.5 mmHg, 35.29 inHg)
or more?
Is the resistance less than 5 Ω? Go to step 4.
Is there poor contact in mani-
fold absolute pressure sensor
connector?
EN(H4SO)(diag)-111
ENGINE (DIAGNOSTICS)
Yes No
Go to step 2. Even if the malfunc-
tion indicator light
illuminates, the cir-
cuit has returned to
a normal condition
at this time. Repro-
duce the fault con-
dition, and
reperform the
check.
NOTE:
In this case, there
may be a tempo-
rary connector
contact failure.
Repair the short Go to step 3.
circuit to power in
the harness
between ECM and
manifold absolute
pressure sensor
connector.
Repair the harness
and connector.
NOTE:
In this case, repair
the following item:
• Open circuit of
harness between
ECM and manifold
absolute pressure
sensor connector.
• Poor contact in
ECM connector
• Poor contact of
coupling connector
Repair the poor Replace the mani-
contact of mani- fold absolute pres-
fold absolute pres- sure sensor. <Ref.
sure sensor to FU(H4SO)-27,
connector. Manifold Absolute
Pressure Sensor.>