Subaru IMPREZA GD 2007 Series Manual page 310

asieps_tobira_IM_US.book 201 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1 CHECK CURRENT DATA.
1) Turn the ignition switch to ON.
2) Read the data of fuel tank pressure sensor
signal using the Subaru Select Monitor or gen-
eral scan tool.
NOTE:
• Subaru Select Monitor
For detailed operation procedures, refer to
"READ CURRENT DATA FOR ENGINE". <Ref.
to EN(H4SO)(diag)-32, Subaru Select Monitor.>
• General scan tool
For detailed operation procedure, refer to the
general scan tool operation manual.
2 CHECK HARNESS BETWEEN ECM AND
FUEL TANK PRESSURE SENSOR CONNEC-
TOR.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from the fuel tank
pressure sensor.
3) Turn the ignition switch to ON.
4) Read the data of fuel tank pressure sensor
signal using the Subaru Select Monitor or gen-
eral scan tool.
NOTE:
• Subaru Select Monitor
For detailed operation procedures, refer to
"READ CURRENT DATA FOR ENGINE". <Ref.
to EN(H4SO)(diag)-32, Subaru Select Monitor.>
• General scan tool
For detailed operation procedure, refer to the
general scan tool operation manual.
3 CHECK HARNESS BETWEEN ECM AND
FUEL TANK PRESSURE SENSOR CONNEC-
TOR.
1) Turn the ignition switch to OFF.
2) Measure the resistance of harness between
fuel tank pressure sensor connector and engine
ground.
Connector & terminal
(R47) No. 2 — Engine ground:
4 CHECK POOR CONTACT.
Check for poor contact of the fuel tank pressure
sensor connector.
Check
Is the measured value 7.98 kPa
(59.86 mmHg, 2.357 inHg) or
more?
Is the measured value 7.98 kPa
(59.86 mmHg, 2.357 inHg) or
more?
Is the resistance less than 5 Ω? Go to step 4.
Is there poor contact in fuel tank
pressure sensor connector?
EN(H4SO)(diag)-201
ENGINE (DIAGNOSTICS)
Yes No
Go to step 2. Even if the malfunc-
tion indicator light
illuminates, the cir-
cuit has returned to
a normal condition
at this time. Repro-
duce the fault con-
dition, and
reperform the
check.
NOTE:
In this case, there
may be a tempo-
rary connector
contact failure.
Repair the short Go to step 3.
circuit to power in
the harness
between ECM and
fuel tank pressure
sensor connector.
Repair the harness
and connector.
NOTE:
In this case, repair
the following item:
• Open circuit of
harness between
ECM and fuel tank
pressure sensor
connector
• Poor contact in
ECM connector
• Poor contact of
coupling connector
Repair the poor Replace the fuel
contact in the fuel tank pressure sen-
tank pressure sen- sor. <Ref. to
sor connector. EC(H4SO)-11,
Fuel Tank Pres-
sure Sensor.>