asieps_tobira_IM_US.book 47 ページ 2012年1月17日 火曜日 午後3時48分
13.Clear Memory Mode
A: OPERATION
1. SUBARU SELECT MONITOR (NORMAL
MODE)
1) On the «Main Menu» display screen, select
{Each System Check}.
2) On the «System Selection Menu» display
screen, select {Engine Control System}.
3) Select the [OK] after the information of engine
type has been displayed.
4) On the «Engine Diagnosis» display screen, se-
lect the {Clear Memory}.
5) When the "Done" and "Turn Ignition Switch OFF"
are shown on the display screen, turn the ignition
switch to OFF, and then Subaru Select Monitor to
OFF.
NOTE:
For detailed operation procedure, refer to the
"SUBARU
SELECT
MANUAL".
2. SUBARU SELECT MONITOR (OBD
MODE)
1) On the «Main Menu» display screen, select
{Each System Check}.
2) On the «System Selection Menu» display
screen, select {Engine Control System}.
3) Select the [OK] after the information of engine
type has been displayed.
4) On the «Engine Diagnosis» display screen, se-
lect {OBD System}.
5) On the «OBD Menu» display screen, select
{DTC Clear}.
6) When the "Clear Diagnostic Code?" is shown on
the screen, select the [OK].
7) Turn the ignition switch to OFF and then close
the Subaru Select Monitor.
NOTE:
For detailed operation procedure, refer to the
"SUBARU
SELECT
MANUAL".
3. GENERAL SCAN TOOL
For clear memory procedures using the general
scan tool, refer to "General Scan Tool Instruction
Manual".
After the memory has been cleared, the idle air
control solenoid valve must be initialized. To do
this, turn the ignition switch to the ON position. Wait
for three seconds before starting the engine.
Clear Memory Mode
MONITOR
OPERATION
MONITOR
OPERATION
EN(H4SO)(diag)-47
ENGINE (DIAGNOSTICS)