Subaru IMPREZA GD 2007 Series Manual page 78

asieps_tobira_IM_US.book 19 ページ ２０１２年１月１７日 火曜日 午後３時４８分
B: INSTALLATION
1) Install the water pump onto cylinder block (LH).
NOTE:
• Use a new gasket.
• When installing the water pump, tighten the bolts
in two stages in alphabetical sequence as shown in
figure.
Tightening torque:
First:
12 N·m (1.2 kgf-m, 8.7 ft-lb)
Second:
12 N·m (1.2 kgf-m, 8.7 ft-lb)
(C)
(D)
(E)
2) Install the hose to the water pump.
3) Install the tensioner bracket.
Tightening torque:
24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
4) Install the belt cover No. 2 (LH).
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
Water Pump
(B)
(A)
(F)
ME-02463
CO-00020
CO-00019
CO(H4SO)-19
5) Install the cam sprocket (LH) using ST.
ST 18231AA010 CAM SPROCKET WRENCH
NOTE:
CAMSHAFT SPROCKET WRENCH (499207100)
can also be used.
Tightening torque:
78 N·m (8.0 kgf-m, 57.9 ft-lb)
6) Install the belt idler No. 2.
Tightening torque:
39 N·m (4.0 kgf-m, 28.9 ft-lb)
7) Install an automatic belt tension adjuster with the
tension rod held by a pin. <Ref. to ME(H4SO)-44,
AUTOMATIC BELT TENSION ADJUSTER AS-
SEMBLY AND BELT IDLER, INSTALLATION,
Timing Belt.>
8) Install the timing belt. <Ref. to ME(H4SO)-45,
TIMING BELT, INSTALLATION, Timing Belt.>
9) Install the crank pulley.
<Ref. to ME(H4SO)-41, INSTALLATION, Crank
Pulley.>
10) Install the V-belts. <Ref. to ME(H4SO)-39, IN-
STALLATION, V-belt.>
11) Install the radiator. <Ref. to CO(H4SO)-24, IN-
STALLATION, Radiator.>
COOLING
S T
CO-00018
CO-00017