Subaru IMPREZA GD 2007 Series Manual page 86

asieps_tobira_IM_US.book 27 ページ ２０１２年１月１７日 火曜日 午後３時４８分
9. Radiator Main Fan and Fan
Motor
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Lift up the vehicle.
4) Remove the under cover.
5) Disconnect the connector of main fan motor (A).
(A)
6) Remove the ATF hose from the clip of the radia-
tor main fan motor assembly. (AT model)
7) Lower the vehicle.
8) Disconnect the over flow hose.
9) Remove the reservoir tank. <Ref. to CO(H4SO)-
31, REMOVAL, Reservoir Tank.>
10) Remove the bolts which hold the radiator main
fan shroud to the radiator.
11) Remove the radiator main fan motor assembly.
Radiator Main Fan and Fan Motor
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
If the installation of the radiator main fan motor as-
sembly is difficult, attempt installation after loosen-
ing the bolts which hold the radiator sub fan motor
assembly.
Tightening torque:
FU-00009
C: DISASSEMBLY
1) Remove the clip which holds the fan motor con-
nector onto the shroud.
2) Remove the nut which holds the fan to the fan
motor.
CO-00274
3) Remove the bolts which hold fan motor onto
shroud.
CO-00096
CO(H4SO)-27
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
COOLING
CO-00096
CO-00047
CO-00048