Subaru IMPREZA GD 2007 Series Manual page 54

asieps_tobira_IM_US.book 11 ページ ２０１２年１月１７日 火曜日 午後３時４８分
23.SECURITY SYSTEM
Check that the security system operates as indicat-
ed below.
1) Fully open all the door windows.
2) Remove the key from the ignition switch and
close all the doors including rear gate.
3) Press the "LOCK/ARM" button on the keyless
transmitter once.
4) If all doors lock, buzzer sounds once, the hazard
light flashes once, and the security display light
flashes as indicated below, the alarm system is in
the monitoring condition.
• Alarm system monitoring prepared condition
(A)
(B)
(A) Light ON
(B) Light OFF
(C) 2 seconds
Pre-delivery Inspection
PI-00357
PI-00264
(C)
PI-00315
PI-11
PRE-DELIVERY INSPECTION
5) Check that the system enters monitoring condi-
tion 30 seconds after the condition in 4).
• Alarm system monitoring condition (all models)
(A)
(B)
(C)
(A) Light ON
(B) Light OFF
(C) 2 seconds
6) Press the "UNLOCK/DISARM" button on the
keyless transmitter once.
7) The alarm system is in the non-monitoring con-
ditions if the driver's side door is unlocked, the
buzzer sounds twice, the hazard light flashes twice,
the room light turns on, and the security display
light turns off.
NOTE:
On models without the immobilizer feature, the se-
curity display light does not flash after the "UN-
LOCK/DISARM" of the keyless transmitter is
pressed.
PI-00265
PI-00358
PI-00264