Subaru IMPREZA GD 2007 Series Manual page 362

asieps_tobira_IM_US.book 253 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1 CHECK OUTPUT SIGNAL OF ECM.
1) Turn the ignition switch to ON.
2) Measure the voltage between ECM and
chassis ground.
Connector & terminal
(B136) No. 28 (+) — Chassis ground (–):
2 CHECK HARNESS BETWEEN ECM AND
PRESSURE CONTROL SOLENOID VALVE.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from the ECM
and pressure control solenoid valve.
3) Measure the resistance between pressure
control solenoid valve and chassis ground.
Connector & terminal
(R68) No. 2 — Chassis ground:
3 CHECK HARNESS BETWEEN ECM AND
PRESSURE CONTROL SOLENOID VALVE.
Measure the resistance of harness between
ECM and pressure control solenoid valve con-
nector.
Connector & terminal
(B136) No. 28 — (R68) No. 2:
4 CHECK PRESSURE CONTROL SOLENOID
VALVE.
Measure the resistance between pressure con-
trol solenoid valve terminals.
Terminals
No. 1 — No. 2:
5 CHECK POWER SUPPLY TO THE PRES-
SURE CONTROL SOLENOID VALVE.
1) Turn the ignition switch to ON.
2) Measure the voltage between pressure con-
trol solenoid valve and chassis ground.
Connector & terminal
(R68) No. 1 (+) — Chassis ground (–):
Check
Is the voltage 10 V or more?
Is the resistance 1 MΩ or
more?
Is the resistance less than 1 Ω? Go to step 4.
Is the resistance between 10 —
100 Ω?
Is the voltage 10 V or more?
EN(H4SO)(diag)-253
ENGINE (DIAGNOSTICS)
Yes No
Repair poor con- Go to step 2.
tact of the ECM
connector.
Go to step 3. Repair short cir-
cuit of the harness
to ground between
ECM and pressure
control solenoid
valve connector.
Repair the harness
and connector.
NOTE:
In this case, repair
the following item:
• Open circuit in
harness between
ECM and pressure
control solenoid
valve connector
• Poor contact of
coupling connector
Go to step 5. Replace the pres-
sure control sole-
noid valve. <Ref. to
EC(H4SO)-12,
Pressure Control
Solenoid Valve.>
Repair the poor Repair the harness
contact of pressure and connector.
control solenoid
NOTE:
valve connector.
In this case, repair
the following item:
• Open circuit in
harness between
main relay and
pressure control
solenoid valve
connector
• Poor contact of
coupling connector
• Poor contact of
main relay connec-
tor