Subaru IMPREZA GD 2007 Series Manual page 430

asieps_tobira_IM_US.book 9 ページ ２０１２年１月１７日 火曜日 午後３時４８分
5. Muffler
A: REMOVAL
CAUTION:
Be careful not to burn yourself, because the ex-
haust pipe becomes extremely hot after run-
ning.
1) Set the vehicle on a lift.
2) Lift up the vehicle.
3) Separate the muffler from rear exhaust pipe.
4) Apply a coat of spray type lubricant to the mating
area of cushion rubber.
5) Remove the front, RH and LH cushion rubbers,
then separate the muffler assembly.
Muffler
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
• Use a new gasket and self-locking nut.
• After assembling, degrease the lubricant which
was applied to the cushion rubber while removing/
installing.
Tightening torque:
48 N·m (4.9 kgf-m, 35.4 ft-lb)
EX-02125
C: INSPECTION
1) Check the connections and welds for exhaust
leaks.
2) Make sure there are no holes or rusting.
3) Check the cushion rubber for wear or crack.
EX-02127
EX(H4SO)-9
EXHAUST
EX-02125