Subaru IMPREZA GD 2007 Series Manual page 56

asieps_tobira_IM_US.book 13 ページ ２０１２年１月１７日 火曜日 午後３時４８分
15) If all doors become locked, the buzzer sounds
once, and the hazard light flashes once, the alarm
system is in the monitoring prepared condition.
• Alarm system monitoring prepared condition
(A)
(B)
(A) Light ON
(B) Light OFF
(C) 2 seconds
16) Check that the system enters monitoring condi-
tion 30 seconds after the condition in 15).
(A)
(B)
(A) Light ON
(B) Light OFF
(C) 2 seconds
17) When the alarm system is in the monitoring
condition, use the inner lock knob or the key to un-
lock the door, and open the door.
18) Check that the alarm condition occurs (horn
sounds continuously, hazard light flashes, security
indicator illuminates).
19) Check that the condition in 18) continues for 30
seconds or more, or until the "UNLOCK/DISARM"
button of the keyless transmitter is pressed.
20) Check that in the monitoring condition, even if
the ignition key is turned to the "START" position,
the starter motor does not turn, and that the engine
does not start.
21) On models equipped with an impact sensor, hit
the front glass with your hand with the alarm sys-
tem in the monitoring condition, to check that the
alarm condition occurs.
22) When none of above is applicable, perform
troubleshooting for the security system. <Ref. to
SL-22, INSPECTION, Security System.>
Pre-delivery Inspection
(C)
PI-00315
(C)
PI-00265
PI-13
PRE-DELIVERY INSPECTION
24.SEAT
1) Check that each seat provides full functionality in
sliding and reclining. Check all available functions of
the rear seat such as a trunk-through center armrest.
2) Check the passenger's seat occupant detection
system.
(1) Turn the ignition switch to ON.
(2) Check that the passenger airbag ON/OFF
indicator lights both turn on simultaneously for
approximately six seconds, and after turning off
for two seconds, only the OFF light illuminates.
(A) Airbag ON/OFF indicator light (U.S. model)
(B) Airbag ON/OFF indicator light (Canada model)
3) With a person weighing approximately 70 kg
(155 lb) or more sitting in the passenger's seat,
check whether the ON light of the passenger's air-
bag ON/OFF indicator illuminates or not.
4) Have the passenger get out of the passenger's
seat, and check whether the OFF light of the pas-
senger side airbag ON/OFF indicator illuminates.
25.SEAT BELT
1) Pull out the seat belt and then release it. Check
that the belt retracts smoothly.
2) Check that the ALR seat belt operates properly.
26.TEST MODE CONNECTOR
Turn the ignition switch to ON and check that the
malfunction indicator light starts blinking. If the light
blinks, return the ignition key to LOCK and discon-
nect the test mode connector. Then, turn the ignition
key to ON again. If the malfunction indicator light
blinks at that time in spite of the disconnected test
mode connector, carry out an engine diagnosis.
(A)
(A) Test mode connector (green)
(A)
(B)
PI-00325
PI-00261