Subaru IMPREZA GD 2007 Series Manual page 84

asieps_tobira_IM_US.book 25 ページ ２０１２年１月１７日 火曜日 午後３時４８分
12) Connect the connectors to the radiator main
fan motor (A) and sub fan motor (B).
13) Install the under cover.
14) Lower the vehicle.
15) Connect the ground cable to the battery.
16) Fill engine coolant. <Ref. to CO(H4SO)-16,
FILLING OF ENGINE COOLANT, REPLACE-
MENT, Engine Coolant.>
17) Check the ATF level. <Ref. to 4AT-28, IN-
SPECTION, Automatic Transmission Fluid.>
Radiator
(A)
CO-00224
(B)
CO-00225
FU-00009
CO(H4SO)-25
C: INSPECTION
1) Remove the radiator cap, fill the radiator with en-
gine coolant, and then install the tester to the instal-
lation position of cap.
2) Apply a pressure of 157 kPa (1.6 kgf/cm
psi) to the radiator and check the following items:
• Leakage from the radiator or its vicinity
• Leakage from the hose or its connections
CAUTION:
• Engine should be turned off.
• Wipe engine coolant from check points in ad-
vance.
• Be careful to prevent engine coolant from
spurting out when removing tester.
• Be careful not to deform the filler neck of ra-
diator when installing and removing the tester.
COOLING
CO-00094
2
, 23