Subaru IMPREZA GD 2007 Series Manual page 401

asieps_tobira_IM_US.book 292 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
1 CHECK ELECTRONIC THROTTLE CON-
TROL RELAY.
1) Turn the ignition switch to OFF.
2) Remove the electronic throttle control relay.
3) Connect the battery to terminals No. 1 and
No. 3 of electronic throttle control relay.
4) Measure the resistance between electronic
throttle control relay terminals.
Terminals
No. 2 — No. 4:
2 CHECK POWER SUPPLY OF ELECTRONIC
THROTTLE CONTROL RELAY.
Measure the voltage between electronic throttle
control relay connector and chassis ground.
Connector & terminal
(B309) No. 2 (+) — Chassis ground (–):
3 CHECK HARNESS BETWEEN ECM AND
ELECTRONIC THROTTLE CONTROL RE-
LAY.
1) Disconnect the connectors from the ECM.
2) Turn the ignition switch to ON.
3) Measure the voltage between electronic
throttle control relay connector and chassis
ground.
Connector & terminal
(B309) No. 3 (+) — Chassis ground (–):
4 CHECK HARNESS BETWEEN ECM AND
ELECTRONIC THROTTLE CONTROL RE-
LAY.
1) Turn the ignition switch to OFF.
2) Measure the resistance between electronic
throttle control relay connector and chassis
ground.
Connector & terminal
(B309) No. 3 — Chassis ground:
(B309) No. 4 — Chassis ground:
5 CHECK HARNESS BETWEEN ECM AND
ELECTRONIC THROTTLE CONTROL RE-
LAY.
Measure the resistance between the ECM and
electronic throttle control relay connector.
Connector & terminal
(B136) No. 21 — (B309) No. 3:
(B136) No. 1 — (B309) No. 4:
Check
Is the resistance less than 1 Ω? Go to step 2.
Is the voltage 10 V or more?
Is the voltage 10 V or more?
Is the resistance 1 MΩ or
more?
Is the resistance less than 1 Ω? Repair poor con-
EN(H4SO)(diag)-292
Yes No
Replace the elec-
tronic throttle con-
trol relay.
Go to step 3. Repair the open or
ground short circuit
of power supply
circuit.
Repair the short Go to step 4.
circuit to power in
the harness
between ECM and
electronic throttle
control relay.
Go to step 5. Repair short cir-
cuit of the harness
to ground between
ECM and elec-
tronic throttle con-
trol relay.
Repair the open
tact of the ECM circuit of harness
connector. between ECM and
electronic throttle
control relay.