Subaru IMPREZA GD 2007 Series Manual page 48

asieps_tobira_IM_US.book 5 ページ ２０１２年１月１７日 火曜日 午後３時４８分
1. APPEARANCE CHECK
• If the vehicle is covered with protective coating, vi-
sually check the vehicle body for damage and dents.
• If there is no protective coat, check the painted
surface of the vehicle body for damage or rust, and
repair as necessary.
• Check the window glass, door glass, and lights for
any cracks or damage, and replace as necessary.
• Visually check the plated parts, such as the
grilles and door knobs, for damage or loss of gloss
and replace the parts as necessary.
2. TIRE CHECK
• Check for damage on the outside surface of the
tires.
• Refer to the following table and inspect the tire
air pressure.
Tire size
Front
P205/55R16 230 (2.3, 33)
215/45R17 230 (2.3, 33)
225/45R17 240 (2.4, 35)
3. FUSE INSTALLATION
Fuses for the room light circuit on initially delivered
vehicles are removed to prevent battery discharge.
Attach the 20 A fuse (A) as shown in the figure.
4. AIR CONDITIONER HARNESS
CONNECTION
Disconnect the air conditioner harness immediately af-
ter vehicle delivery to protect the air conditioner com-
pressor. Connect the harness as shown in the figure.
Pre-delivery Inspection
Tire inflation pressure
2
kPa (kgf/cm , psi)
Rear
210 (2.1, 30)
220 (2.2, 32)
200 (2.0, 29)
(A)
PI-00316
PI-00139
PI-5
PRE-DELIVERY INSPECTION
5. LOCK/UNLOCK AND OPEN/CLOSE
OPERATION CHECKS OF DOORS
1) Using the key, lock and unlock the door several
times to check for normal operation. Open and
close the door several times for smooth movement.
(A)
(A) Unlock
(B) Lock
2) Close the door of driver seat completely, and
place the door lock knob (A) to the lock position.
Then pull the inner remote (B) to ensure that doors
will not open.
For other doors, place the door lock knob (A) to lock
position and then pull the inner remote (B) to en-
sure that doors will not open.
(B)
(A) Door lock knob
(B) Inner remote
(B)
PI-00153
(A)
PI-00004