Subaru IMPREZA GD 2007 Series Manual page 53

asieps_tobira_IM_US.book 10 ページ ２０１２年１月１７日 火曜日 午後３時４８分
PRE-DELIVERY INSPECTION
22.KEYLESS ENTRY SYSTEM
Check the keyless entry system operations as fol-
lows:
• Fully open all the door windows.
• Remove the key from the ignition switch and
close all the doors including rear gate.
• Press the "LOCK/ARM" button momentarily on
the keyless transmitter. Check that all the doors be-
come locked, the buzzer sounds once, and the
hazard lights flash once.
• Press the "UNLOCK/DISARM" button momen-
tarily on the keyless transmitter. Check that the
driver's door is unlocked, the buzzer sounds twice,
and the hazard lights flash twice.
• Within 5 seconds, press the "UNLOCK/DISARM"
button momentarily on the keyless transmitter.
Check that all the doors including rear gate are un-
locked.
• Hold down the "LOCK/ARM" button on the key-
less transmitter for approximately two seconds.
Check that the panic mode (the horn keeps sound-
ing) is initiated. Also, check that this condition con-
tinues for 30 seconds or until when any of the
buttons on the keyless transmitter are pressed.
• Press the "LOCK/ARM" button momentarily on
the keyless transmitter with one of the doors (in-
cluding the rear gate) opened. Check that the buzz-
er sounds 5 times, and the hazard lamp flashes 5
times to notify the door not being fully closed. Next,
close all the doors including rear gate. Check if all
the doors are locked and buzzer sounds once and
the hazard light flashes once.
Pre-delivery Inspection
• With one of the doors open (including the rear
gate), press the "LOCK" side (A) of the power door
lock switch. Next, close all the doors including rear
gate. Check if all the doors are locked and buzzer
sounds once and the hazard light flashes once.
• Driver's side
• Passenger's side
PI-00357
Alarm sound operational check
• The system uses the buzzer and sounds the
alarm when the door is locked or unlocked. The
alarm sound can be turned OFF. To turn the alarm
sound from ON to OFF, close all doors, (with the
key not inserted in the key cylinder), hold down the
"UNLOCK" side of the power door lock switch and
PI-00358
insert the key in the key cylinder. Within 10 sec-
onds, insert and take out the key for 5 times or
more, and within 10 seconds after that, open and
close the door. With the door closed, the hazard
light will flash 3 times, indicating that the alarm
sound has been turned OFF. To turn the alarm
sound from OFF to ON, perform this procedure
again. The hazard lamp will flash 3 times, indicating
that the alarm has been turned ON.
PI-10
(A)
PI-00359
(A)
PI-00360