Subaru IMPREZA GD 2007 Series Manual page 47

asieps_tobira_IM_US.book 4 ページ ２０１２年１月１７日 火曜日 午後３時４８分
PRE-DELIVERY INSPECTION
Checks with the Engine Running
Operation
26. Test mode connector
27. Immobilizer system
28. Starting condition
29. Exhaust system
30. Indicator and warning lights
31. Heater & ventilation
32. Air conditioner
33. Clock
34. Radio
35. Front accessory power supply
socket
36. Lighting system
37. Window washer
38. Wiper
39. Power window operation check
40. Driver's control center differential
Dynamic Test with the Vehicle Running
Operation
41. Brake test
42. Parking brake
43. AT shift control
44. Cruise control
Checks after Dynamic Test
Operation
45. ATF level
46. Power steering fluid level
47. Fluid leak check
48. Water leak inspection
49. Appearance check 2
Pre-delivery Inspection
Test mode connector
1. Check that the engine starts with all keys that are equipped on vehicle.
2. 60 seconds after turning ignition switch from ON to ACC or OFF, or immediately after
removing the key, check that the security indicator light is blinking.
Start the engine and check that the engine starts smoothly.
Check that the exhaust noise is normal and no leaks are found.
Check that all indicator lights and warning lights are operating correctly.
Check that the heater & ventilation system operates normally.
Check that the air conditioner operates normally.
Check that the clock operates normally.
Check the radio and AUX for proper operation.
Check that the front accessory power socket operates normally.
Check that the lighting system operates normally.
Check that the window washer system operates normally.
Check that the wiper system operates normally.
Check that the power window operations normally.
Check that the indicator light operations normally.
Check the foot brake for normal operations.
Check the parking brake for normal operations.
Check that the AT shift patterns are correct.
Check that the cruise control system operates normally.
Check that the ATF level is correct.
Check that the power steering fluid level is normal.
Check for fluid/oil leaks.
Spray the vehicle with water and check for water leaks.
1. Remove the protective coating (if equipped).
2. Check the body paints for damage and stain.
3. Check the plated parts for damage and rust.
PI-4
Check point
Check point
Check point