Subaru IMPREZA GD 2007 Series Manual page 442

asieps_tobira_IM_US.book 11 ページ ２０１２年１月１７日 火曜日 午後３時４８分
C: CAUTION
• Wear appropriate work clothing, including a cap,
protective goggles and protective shoes when per-
forming any work.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Vehicle components are extremely hot after driv-
ing. Be wary of receiving burns from heated parts.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Before disconnecting connectors of sensors or
units, be sure to disconnect the ground cable from
the battery.
• Place "NO OPEN FLAMES" signs near the work-
ing area.
• Prepare a container and cloth to prevent scatter-
ing of fuels when performing work where fuels can
be spilled. If the fuel spills, wipe it off immediately to
prevent from penetrating into floor or flowing out for
environmental protection.
• Follow all government and local regulations con-
cerning disposal of refuse when disposing fuel.
D: PREPARATION TOOL
ILLUSTRATION
ST42099AE000
General Description
TOOL NUMBER DESCRIPTION
42099AE000 CONNECTOR
REMOVER
FU(H4SO)-11
FUEL INJECTION (FUEL SYSTEMS)
REMARKS
Used for removing the quick connector.