Table of Contents
Advertisement
Removing or Replacing the Switch
1. Read the safety information that begins on
2. Detach any cables that are attached to the switch you will be removing.
3. Pull the release latches out from the switch. The switch moves out of the bay
4. Slide the switch out of the bay and set it aside in a safe, static-free location.
5. Place either another switch or a filler module in the bay.
6. If you placed the switch in the bay, reconnect the ports that you disconnected in
20
SI4091 10Gb System Interconnect Module Installation Guide
Note: The following illustration shows how to remove and replace the switch from
the Lenovo Flex System chassis. The appearance of your Lenovo Flex System
chassis might be different; see the documentation for your Lenovo Flex System
chassis for additional information.
To replace the switch, complete the following steps.
page
16.
Note: Detaching cables from the switch ports disrupts the network connection
from the switch to any connected external devices. If you plan to replace
the switch with another switch, you can reuse the existing cables,
provided they remains securely attached to the network.
approximately 0.6 cm (0.25 inch).
Important: Complete this step within 1 minute. For more information, see
"Installing the SI4091" on page
Step 2
and attach any additional cables that are required by the switch.
For additional information about connecting ports, see
Ports" on page
21, and also the documentation that comes with the port
transceiver modules, DACs, cables, and the optional network devices to which
the cables have been connected.
page
5, and
"Installation Guidelines" on
18.
"Connecting Switch
Advertisement
Table of Contents
