SSANGYONG KYRON 2010.01 Manual page 785

13-15
4890-01
The rubber O-ring in IWE (Integrated Wheel End) should be replaced with new one when the
front wheel end has been removed.
The rubber O-ring prevents moisture and foreign materials from entering the IWE system.
In addition, when installing the hub actuator of the IWE system, you must install it from the same
angle as the drive shaft to prevent the rubber seal ring inside the actuator from being squeezed.
Rubber
O-ring
Rubber seal ring
(Internal steel spring included)
Please refer to the part time transfer case section for more specific information.
ESP
KYRON 2010.01