SSANGYONG KYRON 2010.01 Manual page 784

13-14
4890-01
Cautions When Removing the Front Wheel Speed Sensor
The locking hub system of the KYRON part time 4WD utilizes a different hub actuator from the
conventional approach. It utilizes IWE (Integrated Wheel End) system that locks the 4WD
depending on the vacuum condition within the actuator.
Thus, the wheel speed sensor is installed on the front wheel end area. It is installed inside the
backing plate to be protected from heat and foreign materials. Therefore, the front wheel end
system (including disc) should be removed before removing the front wheel speed
sensor.
Front Wheel Speed Sensor (4WD)
Backing plate
Wheel speed sensor
Wheel speed sensor
ESP
KYRON 2010.01
Rear Wheel Speed Sensor (IRS Type)
Wheel Speed Sensor
Backing plate