SSANGYONG KYRON 2010.01 Manual page 80

4. COMPONENTS OF LOW PRESSURE TRANSFER LINE
Low pressure stage is to supply sufficient fuel to high pressure section and components are as
below.
- Fuel tank (including strainer)
- Hand priming pump
- Fuel filter
- Transfer pump
- Other low pressure fuel hoses
1) Fuel Tank
2) Priming Pump
Fuel tank is made of anti-corrosion material
and its allowable pressure is 2 times of
operating pressure (more than min. 0.3 bar).
It has protective cap and safety valve to
prevent excessive pressure building. Also, to
supply fuel smoothly, it has structure to
prevent fuel from leaking in shocks, slopes
and corners and.
If fuel runs out during driving or air gets into
fuel line after fuel filter replacement, it may
cause poor engine starting or damage to
each component. Therefore,
priming pump is installed to bleed air from
transfer line.
When the vehicle is under the conditions as
below, press the priming pump until it
becomes rigid before starting the engine.
- After run out of fuel
- After draining the water from fuel separator
- After replacing the fuel filter
Press the priming pump until it becomes
rigid before starting the engine.
ENGINE FUEL SYSTEM
03-9
1881-01
the hand
undefined