SSANGYONG KYRON 2010.01 Manual page 771

11-14
3310-00
PROPELLER SHAFT
KYRON 2010.01
3) Assembly
Clean the components and replace if damaged.
1. Align the alignment marks on the yoke
and assemble the spider, bearing and
snap ring.
2. Apply the grease to the inner lip of
needle roller bearing and assemble the
needle roller.
3. Install the yoke bearing shaft on the shaft
and insert the spider. Place the cap on
the opposite side and tap it with plastic
hammer to seat it. Adjust the clearance
of spider below 0.1 mm and install the
snap ring.
4. Install the intermediate bearing to the
rear propeller shaft.
5. Apply the grease on the propeller shaft
and install it.