SSANGYONG KYRON 2010.01 Manual page 813

13-43
4890-01
Cautions When Removing the Front Wheel Speed Sensor
The locking hub system of the KYRON part time 4WD utilizes a different hub actuator from the
conventional approach.
It utilizes IWE (Integrated Wheel End) system that locks the 4WD depending on the vacuum
condition within the actuator.
Thus, the wheel speed sensor is installed on the front wheel end area. It is installed inside the
backing plate to be protected from heat and foreign materials.
Therefore, the front wheel end system (including disc) should be removed before
removing the front wheel speed sensor.
Front Wheel Speed Sensor Rear Wheel Speed Sensor
Backing Plate
Wheel Speed Sensor
Backing Plate
Wheel Speed Sensor
ESP
KYRON 2010.01