SSANGYONG KYRON 2010.01 Manual page 427

▶ Leakage Test
- Warm the engine up to normal operating temperature.
- Disconnect the negative battery cable.
- Remove the spark plugs.
- Check the coolant level by opening the coolant reservoir cap and replenish if insufficient.
- Open the engine oil filler cap.
- Connect the tester to air pressure line and adjust the scale of tester.
- Install the connecting hose to spark plug hole.
- Position the piston of No.1 cylinder at TDC by rotating the crankshaft.
- Connect the connecting hose to tester and measure the leakage volume after blowing up
5 bar of compressed air.
- Measure the leakage volume in the completely opening condition of throttle valve by
pulling the acceleration cable.
- Perform the pressure test according to the firing order.
- Firing Order: 1 - 3 - 4 - 2
- Compare the leakage pressure with the specifications.
01-13
1113-01
ENGINE ASSEMBLY
KYRON 2010.01