Interface State - TP-Link T3700G-52TQ User Manual

Version:
Robustness:
Query Interval:
Query Max
Response Time:
Startup Query
Interval:
Startup Query
Count:
Last Member Query
Interval:
Last Member Query
Count:
Profile ID:

11.2.3 Interface State

Choose the menu Multicast Routing→IGMP→Interface State to load the following page.
The following entries are displayed on this screen:
Search Option

All:
Interface VLAN:
There are three versions for IGMP protocol.
IGMPv1: the interface is now an IGMPv1 Router.

IGMPv2: the interface is now an IGMPv2 Router.

IGMPv3: the interface is now an IGMPv3 Router.

Specify the robustness of the selected interface, ranging
from 1 to 255. The default is 2.
Specify the IGMP query interval at which IGMP router sends
out a general query, ranging from 1 to 3600 . The default is
125 seconds.
When IGMP router sends out a query packet, the host
should response within the specified Query Max Response
Time, the value is in tenths of a second, ranging from 0 to
255 . The default is 100(10 seconds).
When IGMP router starts up, it will send out a general query
every Startup Query Interval, ranging from 1 to 300. The
default is 31 seconds.
The number of general queries to be sent on startup,
ranging from 1 to 20. The default is 2.
When the last member leaves a multicast group, IGMP router
will send out a specific query every Last Member Query
Interval, the value is in tenths of a second, ranging from 0 to
255. The default is 10(1 seconds).
The number of queries to be sent on receiving a leave group
report, ranging from 1 to 20. The default is 2.
The Profile ID bound to the selected interface, ranging from
0 to 999.The value 0 means bound to none.
Figure 11-6 Interface State
Displays all interface entries.
Enter the VLAN ID the desired entry must carry.
262