Route Redistribution - TP-Link T3700G-52TQ User Manual

State:

10.9.8 Route Redistribution

Choose the menu Routing→OSPF→Route Redistribution to load the following page.
Configuration Procedure:
1) Select a Source to be enabled with Route Redistribution.
2) Enable Route Redistribution and configure the relevant parameters.
3) Click Apply.
Entry Description:
Route Redistribution

Process:
Select:
Source:
Redistribute:
Metric:
Displays the current state of the selected router interface.
One of:
Down: This is the initial interface state. In this state, the

lower-level protocols have indicated that the interface
is unusable. In this state, interface parameters will be
set to their initial values. All interface timers will be
disabled, and there will be no adjacencies associated
with the interface.
P2P: In this state, the interface is operational, and

connects either to a physical point-to-point network or
to a virtual link. Upon entering this state, the router
attempts to form an adjacency with the neighboring
router. Hello Packets are sent to the neighbor every
HelloInterval seconds.
Figure10-53 Route Redistribution
Select one OSPF Process to display its route redistribution
list.
Select the desired item for configuration. It is multi-optional.
The available source routes for redistribution by OSPF. The
valid values are 'Static', 'RIP', 'Connected', and other OSPF
processes.
This option enables or disables the redistribution for the
selected source protocol.
Set the metric value to be used as the metric of redistributed
routes. The valid value ranges from 1 to 16777214 and the
default is equal to Default Metric configured on Basic page.
233