Switching module is used to configure the basic functions of the switch, including four
submenus: Port, LAG, Traffic Monitor and MAC Address.
6.1 Port
The Port function, allowing you to configure the basic features for the port, is implemented on
the Port Config, Port Mirror, Port Security, Protected Ports and Loopback Detection pages.
6.1.1 Port Config
On this page, you can configure port status, speed mode, duplex mode, flow control and jumbo
frames for ports.
Choose the menu Switching→Port→Port Config to load the following page.
Configuration Procedure:
Select and configure your desired ports or LAGs. Then click Apply to make the settings
effective.
Entry Description:
UNIT:
Type:
Chapter 6 Switching
Figure 6-1 Port Config
Click 1 to configure physical ports. Click LAGS to configure
LAGs.
Displays the port type. Copper indicates an Ethernet port,
and Sfp indicates a fiber port.
53