Backup Log - TP-Link T3700G-52TQ User Manual

Configuration Procedure:
Select an entry to enable the status, and then set the host IP address and severity. Click Apply to
make the settings effective.
Entry Description:
Admin Mode:
Index:
Host IP:
UDP Port:
Severity:
Status:
Note:
The Log Server software is not provided. If necessary, please download it on the Internet.

17.2.4 Backup Log

Backup Log feature enables the system logs saved in the switch to be output as a file for
device diagnosis and statistics analysis. When a critical error results in the breakdown of the
system, you can export the logs to get some related important information about the error for
device diagnosis after the switch is restarted.
Choose the menu Maintenance → Log → Backup Log to load the following page.
Configuration Procedure:
Click Backup Log to save the system log as a file on your computer. If the switch system breaks
down, you can check the file for troubleshooting.
Enable or disable the log host. While enabled, syslog packets
will be sent to the hosts. While disabled, no syslog packets
will be sent to the hosts.
Displays the index of the log host. The switch supports 8 log
hosts.
Configure the IP for the log host.
Displays the UDP port used for receiving/sending log
information. Here we use the standard port 514.
Specify the severity level of the log information sent to each
log host. Only the log with the same or smaller severity level
value will be sent to the corresponding log host.
Displays the status of the corresponding log host.
Figure17-6 Backup Log
406