TP-Link T3700G-52TQ User Manual page 83

Configuration Procedure:
1) To get the real-time traffic summary, enable auto refresh in the Auto Refresh section, or
click Refresh at the bottom of the page.
2) In the Traffic Summary section, click 1 to show the information of the physical ports, and
click LAGS to show the information of the LAGs.
Entry Description:
Auto Refresh

Auto Refresh:
Refresh Rate:
Statistics

Received:
Sent:
Broadcast:
Multicast:
Unicast:
Jumbo
Alignment Errors:
UndersizePkts:
Pkts64Octets:
Pkts65to127Octets:
Pkts128to255Octets:
Pkts256to511Octets:
Allows you to Enable/Disable refreshing the Traffic Summary
automatically.
Enter a value in seconds to specify the refresh interval.
Displays the details of the packets received on the port.
Displays the details of the packets transmitted on the port.
Displays the number of good broadcast packets received or
sent on the port. Error frames are not counted in.
Displays the number of good multicast packets received or
sent on the port. Error frames are not counted in.
Displays the number of good unicast packets received or
sent on the port. Error frames are not counted in.
Displays the number of jumbo frames received or sent on the
port.
Displays the number of the received packets that have a bad
Frame Check Sequence (FCS) with a non-integral octet
(Alignment Error) and have a bad FCS with an integral octet
(CRC Error). The length of the packet is between 64 bytes
and 1518 bytes.
Displays the number of the received packets (excluding error
packets) that are less than 64 bytes long.
Displays the number of the received packets (including error
packets) that are 64 bytes long.
Displays the number of the received packets (including error
packets) that are between 65 and 127 bytes long.
Displays the number of the received packets (including error
packets) that are between 128 and 255 bytes long.
Displays the number of the received packets (including error
packets) that are between 256 and 511 bytes long.
70