TP-Link T3700G-52TQ User Manual page 285

Choose the menu Multicast Routing→PIM DM→PIM DM neighbor to load the following page.
The following entries are displayed on this screen:
Search Option

The L3 interfaces can be configured as PIM DM mode by this page.
Search Option:
PIM DM Neighbor

Interface:
Neighbor:
Uptime:
Expires:
Configuration Procedure for PIM DM:
Step Operation
1 Configure
interface
2 Configure routing
protocol
3 Enable multicast
routing and PIM
DM
Figure 11-14 PIM DM neighbor
ALL: Displays all entries.

Neighbor: Select Neighbor and enter the neighbor

address of your desired entry.
Interface：Select interface and enter the interface ID of

your desired entry.
The physical interface on which PIM DM is enabled.
The IP address of the PIM neighbor for which this entry
contains information.
The time since the PIM neighbor (last) became a neighbor of
the local switch.
The time remaining before the PIM neighbor will be aged out.
Description
Required. Configure IP addresses and subnet masks of routing
interfaces on Routing→Interface→Interface Config page.
Required. Configure the routing entries via static route or
dynamic routing protocol like OSPF, and make sure all network
can communicate with each other and update the routing
information through a unicast routing protocol dynamically.
Required. Enable multicast routing on Multicast Routing→Global
Config page. Enable PIM DM on routing interfaces on Multicast
Routing→PIM DM→PIM DM Interface page.
272