Installing A Hard Disk - Huawei RH2288 V3 User Manual

RH2288 V3 Server
User Guide
Step 5 Push the ejector release button on the hard disk. See step (1) in
The ejector lever automatically ejects.
Figure 7-8 Removing a hard disk
Step 6 Hold the ejector lever, and pull out the hard disk for about 3 cm (1.18 in.). See step (2) in
Figure
hard disk from the RH2288 V3. See step (3) in
Step 7 Place the removed hard disk in an ESD bag.
Step 8 (Optional) If you do not install a new hard disk immediately, install a filler panel in the slot.
----End

7.6 Installing a Hard Disk

Install a hard disk to replace the original one or add a new hard disk.
You do not need to power off the RH2288 V3 before installing a hard disk.
After a failed hard disk is disconnected from the disk backplane, wait for 30 seconds before
removing it and inserting a new one. The alarm persists after a new hard disk is installed and
will be cleared after the RAID array is rebuilt. Do not frequently hot-swap a hard disk to
prevent new alarms.
Procedure
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Remove the hard disk to be replaced. For details, see
Step 3 Take the spare hard disk out of its ESD bag.
Step 4 Fully raise the ejector lever and push the hard disk into the chassis along the guide rails until
it does not move. See step (1) in
Issue 32 (2019-03-28)
7-8. Wait for at least 30 seconds until the hard disk stops working. Then remove the
Copyright © Huawei Technologies Co., Ltd.
Figure 7-8.
1 Safety Instructions.
7.5 Removing a Hard
Figure 7-9.
7 Replacing Parts
Figure 7-8.
Disk.
137