Removing An Nvme Pcie Ssd; Installing An Nvme Pcie Ssd; Removing A Psu; Removing An Ac Psu - Huawei RH2288 V3 User Manual

RH2288 V3 Server
User Guide
Figure 7-9 Installing a hard disk
Step 5 Ensure that the ejector lever is fastened to the chassis beam, and lower the ejector lever to
completely insert the hard disk into the chassis. See step (2) in
Observe the hard disk indicators to check the hard disk operating status. For details about the
indicators, see
Step 6 If a front hard disk is installed and the bezel is required, install the bezel. For details, see
(Optional) Installing the Front
Step 7 After verifying hard disk status, configure RAID properties based on actual service
requirements. For details, see the
----End

7.7 Removing an NVMe PCIe SSD

For details, see "Removing an ES3000 V3" in the

7.8 Installing an NVMe PCIe SSD

For details, see "Installing ES3000 V3" in the

7.9 Removing a PSU

7.9.1 Removing an AC PSU

Remove an AC PSU before replacing it with a new one.
When two PSUs are configured, remove one PSU without powering off the RH2288 V3 if the
other PSU is operating properly and its power rating is greater than or equal to the power
rating of the RH2288 V3.
Observe the PSU indicators to check the PSU operating status. For details about the
indicators, see
Issue 32 (2019-03-28)
2.4 Indicators and Buttons.
Bezel.
Huawei V2&V3 Server RAID Controller Card User
2.4 Indicators and Buttons.
Copyright © Huawei Technologies Co., Ltd.
Figure
ES3000 V3 NVMe PCIe SSD User
ES3000 V3 NVMe PCIe SSD User
7 Replacing Parts
7-9.
7.4
Guide.
Guide.
Guide.
138